EATON SP1 surge protector has a compact 50KA per phase footprint, with half-inch molded nipple and optional din rail mounting kit that make this surge protection device easy to install on point of use locations, control panels, load centers and small distribution panel (up to 200amp). With an industry best 20KA nominal discharge rating and low VPR ratings, EATON Sp1 surge protective device is a UL 1449 4th edition surge device that provides reliable, cost-effective surge protection.

EATON Surge Protective Device, Series: SP1, 277/480Y VAC Electrical Rating, 50/60 Hz Frequency, 200 kA Short Circuit, 50 kA Peak Surge Current, 20 kA Nominal Discharge, Modes of Protection: 640 L-G/320 L-N, LED Indicator, 3 ph, Environmental Conditions: -4 to 122 deg F Operating Temperature, 5 to 95% Non-Condensing Operating Humidity, NEMA 4 Enclosure, DIN Rail/Wall Mounting, 2.5 in L x 2.9 in W x 4.8 in H Dimensions

• Type 1 SPD capable of installation on either the line or load side of the service entrance disconnect
• Pre-wired with 24 in of 10 AWG wire
• 1/2 in nipple molded into enclosure enables quick and easy mounting
• Optional kit enables wall or DIN rail mounting

• Instruction/Installation Manual IDW_DOCUMENT_97a53ec7dad46367f2f4d40e497fc49ae5f064bab933f8729b9dab175cdafe8b.pdf
• Specification Sheet IDW_DOCUMENT_518bcb7b371b85dd21e76dbba691fb7c6379fed1b695706134b19c8b291c5a47.pdf